AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Ductwork Repair: The Henderson Owner’s Guide
Lennox ductwork repair in Henderson typically costs $150 – $650 installed, depending on how much of the duct run needs sealing, patching, or replacement, and we keep Lennox-compatible duct materials on our trucks for same-day service in most cases. Most homeowners discover a duct problem the same way: one room stays stubbornly warm in July while the rest of the house cools fine, or the utility bill creeps up month after month with no obvious explanation. Sometimes it’s a musty smell when the blower kicks on, sometimes it’s a whistling sound behind a wall, sometimes it’s just dust settling on the furniture faster than it used to. Whatever tipped you off, the fix is usually straightforward once someone actually looks at the duct run and finds where the air is going instead of where it should. If you’re calling about ducts, you usually need someone who will get into the attic or crawlspace, measure the damage, and tell you straight what it costs to make it right.
Which Lennox Models This Applies To
Ductwork itself is not model-specific the way a control board or a blower motor is, but the way your Lennox system pushes air through those ducts absolutely is. We work on duct runs connected to Lennox Elite, Merit, and Dave Lennox Signature Collection systems, and the main thing we check is static pressure: high-efficiency Lennox units with variable-speed blowers, like the SLP98V or XC25, are far less forgiving of undersized or leaky ducts than older single-stage systems. A 16-inch return that was adequate for a 2008 Merit furnace may choke a newer variable-speed unit and shorten its blower life. When it comes to replacement materials, we use sheet metal, flex duct, and mastic sealant rated for the desert climate here, and for Lennox systems we default to OEM-grade duct components rather than big-box store equivalents because the gauge and insulation values are speced to the airflow your unit was designed around. The label on your indoor unit will list the model number, and that tells us the CFM range we need your ducts to support.
Styles & brands we work with







Signs Your Lennox Ductwork Repair Is Failing
- One room never reaches the thermostat setting. A disconnected or crushed duct branch is sending conditioned air into the attic or wall cavity instead of the room. In Green Valley homes with two-story layouts, we usually find the problem on the upstairs run that snakes through the hottest part of the attic.
- Dust appears on surfaces days after cleaning. Return-side leaks pull unfiltered attic air into the system, so whatever is in your attic, insulation fibers, blown dust, the fine grit that Henderson wind pushes under roof tiles, ends up circulating through the house.
- A whistling or rumbling noise when the blower runs. Air escaping through a small gap makes a whistle; a section of flex duct that has sagged and kinked makes a lower rumbling sound as air fights through the restriction.
- Utility bills higher than the same month last year, with no change in usage. Leaky ducts can lose 20 to 30 percent of conditioned air before it ever reaches a register, which means your Lennox system runs longer to satisfy the thermostat.
- Weak airflow from specific registers. If one vent barely moves a tissue while another feels like a wind tunnel, you likely have a duct separation or a damper that has worked itself closed. We find a lot of disconnected takeoffs in attics where the original install used too few straps and the Nevada heat softened the duct tape adhesive.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Henderson, plan on $150 – $650 for the large majority of Lennox ductwork repairs we do. A simple reseal of a separated joint with mastic and new straps runs near the bottom of that range, while a full branch replacement with new flex duct, insulation, and register reconnection lands in the middle. The upper end covers jobs like replacing a crushed return trunk or rebuilding a plenum connection, especially in tight attic spaces in older Green Valley homes. We write the price before any work starts, so you know the number includes the part, the labor, the mastic, the straps, and the time it takes to do it right. Every repair carries our 365-Day Done Right Promise: if the fix doesn’t hold, we come back and make it right, no runaround. As an independent service provider, we are not affiliated with Lennox, but we service the full Lennox line and stand behind our duct repairs the same way we would on any of the other eight brands we support.
DIY or Call Us?
What you can safely do: check the registers and returns for obvious blockage, look at exposed duct sections in your garage or utility closet for gaps or sagging, and replace a clogged filter, because a starved system pulls harder on every duct joint. What we would not recommend: crawling into a Henderson attic in July to peel back insulation and hunt for a leak yourself. Attic temperatures here regularly exceed 130°F in summer, and a misstep through a ceiling or a brush against a hot vent pipe is a real risk. Duct sealing done badly, think duct tape instead of mastic, which dries out and fails within a season in our dry heat, often makes the problem worse. If the symptoms match what we described above, call Luis Serrano and the crew at Meadowsweet Heating and Air Henderson at (775) 257-9022. We’ll schedule the visit, price the repair in writing before touching anything, and leave your attic cleaner than we found it.
FAQs
Flex duct in the Henderson area typically lasts 15 to 20 years before the inner liner degrades or the insulation breaks down, but attic heat and the wide temperature swings we get between July and January can shorten that to 10 to 12 years in poorly ventilated attics. Sheet metal ductwork lasts far longer, often the life of the house, but its joints and connections still need resealing periodically.
Yes, and in most cases repair is the right call: a separated joint, a small tear, a crushed section, or a failing connection can all be fixed with mastic, new straps, or a targeted flex replacement for $150 – $650. Full replacement only makes sense when the duct system is undersized for your Lennox unit or the insulation has degraded across the entire run, and we will tell you plainly if repair is throwing money at a losing battle.
Most attic or crawlspace duct runs we repair in Henderson take 1 to 3 hours, depending on access, and we carry common Lennox-compatible duct materials on the truck so we are not scheduling a second visit for parts. Larger rebuilds can take a half day, but we give you a clear time window before the crew starts.
We stock the most common duct repair components, flex duct in standard diameters, mastic, straps, takeoffs, and sheet metal for plenum work, so most Lennox duct repairs we handle are done same-day. Less common sizes or specialty components may take a day to source, and we will tell you that before quoting the job. Call (775) 257-9022 and a live person answers, any hour, any day.
Written by Luis Serrano, Owner, Meadowsweet Heating and Air Henderson at Meadowsweet Heating and Air Henderson, serving Henderson and nearby areas.